Skip to content

Switches Configuration (v0.9.x YAML)

[!WARNING] Legacy Configuration: This page describes manual YAML configuration in /config/myhome.yaml used by MyHOME v0.9.x. In MyHOME v2.0+, switches are configured directly via the Home Assistant user interface.

The configuration is largely the same as lights, except switches are non-dimmable binary relays, and you can specify class if you wish to distinguish between outlet and switch.

Configuration Example

f454:
  mac: '00:03:50:xx:xx:xx'
  switch:
    bed_heater:
      where: '0211'
      name: Mattress heating pad
      class: outlet
      manufacturer: BTicino
      model: F411U2
    door_bell:
      where: '0515'
      interface: '02'
      name: Doorbell
      class: switch
      manufacturer: BTicino
      model: 3476
    hvac_relay_1:
      where: '08'
      name: HVAC relay 1
      class: switch
      manufacturer: Arnould
      model: 64391

Parameters

  • where (mandatory): OpenWebNet bus address of the relay (2 or 4 digits).
  • name (mandatory): Friendly name for the switch entity in Home Assistant.
  • interface (optional): Bus interface ID when located behind an F422 bus-to-bus interface.
  • class (optional): Device class for Home Assistant (switch or outlet).
  • manufacturer (optional): Cosmetic manufacturer name.
  • model (optional): Cosmetic model designation.